Dell Force10 MXL Blade - Ip Ssh Authentication-Retries; Ip Ssh Connection-Rate-Limit

Security | 557
Parameters
Defaults
The internal flash (flash:) is the default directory.
Command Modes
CONFIGURATION
Command
History
Usage
Information
To configure the switch as a SCP server, use the ip ssh server command.
Related
Commands
ip ssh authentication-retries
Configure the maximum number of attempts that should be used to authenticate a user.
Syntax
ip ssh authentication-retries 1-10
Parameters
Defaults
3
Command Modes
CONFIGURATION
Command
History
Usage
Information
This command specifies the maximum number of attempts to authenticate a user on a SSH connection
with the remote host for password authentication. SSH disconnects when the number of password
failures exceeds authentication-retries.
ip ssh connection-rate-limit
Configure the maximum number of incoming SSH connections per minute.
Syntax
ip ssh connection-rate-limit 1-10
Parameters
Defaults
10 per minute
Command Modes
CONFIGURATION
directory
Enter a directory name.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
ip ssh server Enables the SSH and SCP server on the switch.
1-10
Enter the number of maximum retries to authenticate a user.
Range: 1 to 10
Default: 3
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
1-10
Enter the number of maximum number of incoming SSH connections allowed per
minute.
Range: 1 to 10 per minute
Default: 10 per minute