Dell Force10 MXL Blade - Show Config; Set Tag; Show Route-Map

140 | Access Control Lists (ACL)
www.dell.com | support.dell.com
set tag
Configure a filter to specify a tag for redistributed routes.
Syntax
set tag tag-value
Parameters
Defaults
Not configured
Command Modes
ROUTE-MAP
Command
History
Related
Commands
show config
Display the current route map configuration.
Syntax
show config
Command Modes
ROUTE-MAP
Command
History
Example
Figure 6-13. show config Command Example
show route-map
Display the current route map configurations.
Syntax
show route-map [map-name]
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
tag-value
Enter a number as the tag.
Range: zero (0) to 4294967295.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
set automatic-tag Computes the tag value of the route.
set metric Specifies the metric value assigned to redistributed routes.
set metric-type Specifies the route type assigned to redistributed routes.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
FTOS(conf-route-map)#show config
!
route-map hopper permit 10
FTOS(conf-route-map)#
map-name
(OPTIONAL) Enter the name of a configured route map, up to 140 characters.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module