20 | CLI Basics
www.dell.com | support.dell.com
MULTIPLE SPANNING TREE Mode
Use MULTIPLE SPANNING TREE mode to enable and configure the multiple spanning tree protocol
(MSTP), as described in Multiple Spanning Tree Protocol (MSTP).
To enter MULTIPLE SPANNING TREE mode:
1. Verify that you are logged into CONFIGURATION mode.
2. Enter the protocol spanning-tree mstp command.
You can return to CONFIGURATION mode by using the exit command.
PROTOCOL GVRP Mode
Use the PROTOCOL GVRP mode to enable and configure generic attribute registration protocol
(GARP) virtual LAN (VLAN) registration protocol (GVRP), as described in GARP VLAN
Registration (GVRP).
To enter PROTOCOL GVRP mode:
1. Verify that you are logged into CONFIGURATION mode.
2. Enter the protocol gvrp command syntax.
You can return to CONFIGURATION mode by using the exit command.
ROUTER OSPF Mode
Use the ROUTER OSPF mode to configure open shortest path first (OSPF), as described in Open
Shortest Path First (OSPFv2).
To enter ROUTER OSPF mode:
1. Verify that you are logged into CONFIGURATION mode.
2. Use the router ospf {process-id} command.The prompt changes to include (conf-router_ospf-id).
You can switch to INTERFACE mode by using the interface command or you can switch to ROUTER
RIP mode by using the router rip command.
ROUTER RIP Mode
Use the ROUTER RIP mode to configure routing information protocol (RIP), as described in Routing
Information Protocol (RIP).
To enter ROUTER RIP mode:
1. Verify that you are logged into CONFIGURATION mode.
2. Enter the router rip command.The prompt changes to include (conf-router_rip).
You can switch to INTERFACE mode by using the interface command or you can switch to ROUTER
OSPF mode by using the router ospf command.
To Next Page
Loading...
