Dell Force10 MXL Blade - LINE Mode; MAC ACCESS LIST Mode; IP ACCESS LIST Mode; ROUTE-MAP Mode

18 | CLI Basics
www.dell.com | support.dell.com
LINE Mode
Use LINE mode to configure console or virtual terminal parameters.
To enter LINE mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the line command. You must include the keywords console or vty and their line number
available on the switch.The prompt changes to include (config-line-console) or (config-line-vty).
You can exit this mode by using the exit command.
MAC ACCESS LIST Mode
While in CONFIGURATION mode, use the mac access-list standard or mac access-list extended
commands to enter MAC ACCESS LIST mode and configure either standard or extended access
control lists (ACL).
To enter MAC ACCESS LIST mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Use the mac access-list standard or mac access-list extended command. You must include a
name for the ACL.The prompt changes to include (conf-std-macl) or (conf-ext-macl).
You can return to CONFIGURATION mode by using the exit command.
IP ACCESS LIST Mode
While in CONFIGURATION mode, use the ip access-list standard or ip access-list extended
commands to enter IP ACCESS LIST mode and configure either standard or extended access control
lists (ACL).
To enter IP ACCESS LIST mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Use the ip access-list standard or ip access-list extended command. You must include a name
for the ACL.The prompt changes to include (conf-std-nacl) or (conf-ext-nacl).
You can return to CONFIGURATION mode by using the exit command.
ROUTE-MAP Mode
While in CONFIGURATION mode, use the route-map command to enter ROUTE-MAP mode and
configure a route map.
To enter ROUTE-MAP mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Use the route-map map-name [permit | deny] [sequence-number] command. The prompt
changes to include (route-map).
You can return to CONFIGURATION mode by using the exit command.