Dell Force10 MXL Blade - Show Uplink-State-Group

650 | Uplink Failure Detection (UFD)
www.dell.com | support.dell.com
Command
History
Example
Figure 36-2. show running-config uplink-state-group Command Example
Related
Commands
show uplink-state-group
Display status information on a specified uplink-state group or all groups.
Syntax
show uplink-state-group [group-id] [detail]
Parameters
Defaults
none
Command Modes
EXEC
EXEC Privilege
Command
History
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
FTOS#show running-config uplink-state-group
!
uplink-state-group 3
no enable
description Testing UFD feature
downstream disable links 2
downstream TenGigabitEthernet 0/1-2,5,9,11-12
upstream TenGigabitEthernet 0/3-4
show uplink-state-group Displays status information on a specified uplink-state group or all groups.
uplink-state-group Creates an uplink-state group and enable the tracking of upstream links.
group-id Displays status information on a specified uplink-state group or all
groups. Valid group-id values are 1 to 16.
detail Displays additional status information on the upstream and
downstream interfaces in each group
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module