Dell Force10 MXL Blade - Other Commands supported by DHCP Client

Dynamic Host Configuration Protocol (DHCP) | 195
Other Commands supported by DHCP Client
• clear ip dhcp client statistics
• debug ip dhcp clients events
• debug ip dhcp clients packets
• release dhcp interface
• renew dhcp interface
• show ip dhcp client statistics
• show ip dhcp lease
clear ip dhcp client statistics
Display DHCP client statistics, including the number of DHCP messages sent and received on an
interface.
Syntax
clear ip dhcp client statistics {all | interface type slot/port}
Parameters
Command Mode
EXEC Privilege
Default
None.
Command
History
debug ip dhcp clients events
Enable the display of log messages for the following events on DHCP client interfaces:
• IP address acquisition
• IP address release
• Renewal of IP address and lease time
• Release of an IP address
Syntax
debug ip dhcp client events [interface type slot/port]
Parameters
all
Clear DHCP client statistics on all DHCP client-enabled interfaces on the switch.
interface type slot/
port
Clear DHCP client statistics on the specified interface.
For a 10-GigabitEthernet Ethernet interface, enter TenGigabitEthernet followed
by the slot/port numbers; for example, tengigabitethernet 1/3.
For a 40-GigabitEthernet Ethernet interface, enter FortyGigabitEthernet followed
by the slot/port numbers; for example, fortygigabitethernet 0/2.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
interface type slot/
port
Display log messages for DHCP events on the specified interface.
For a 10-GigabitEthernet Ethernet interface, enter TenGigabitEthernet followed
by the slot/port numbers; for example, tengigabitethernet 1/3.
For a 40-GigabitEthernet Ethernet interface, enter FortyGigabitEthernet followed
by the slot/port numbers; for example, fortygigabitethernet 0/2.