Dell Force10 MXL Blade - Snmp-Server Location

590 | Simple Network Management Protocol (SNMP) and Syslog
www.dell.com | support.dell.com
To send an inform, follow these steps:
1. Configure a remote engine ID.
2. Configure a remote user.
3. Configure a group for this user with access rights.
4. Enable traps.
5. Configure a host to receive informs.
Related
Commands
snmp-server location
Configure the location of the SNMP server.
Syntax
snmp-server location text
To delete the SNMP location, use the no snmp-server location command.
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
snmp-server packetsize
Set the largest SNMP packet size permitted when the SNMP server is receiving a request or generating
a reply, use the snmp-server packetsize global configuration command.
Syntax
snmp-server packetsize byte-count
Parameters
Defaults
8
Command Modes
CONFIGURATION
Command
History
snmp-server enable traps Enables the SNMP traps.
snmp-server community Configures a new community SNMPv1 or SNMPv2c.
text
Enter an alpha-numeric text string, up to 55 characters long.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
byte-count
Enter one of the following values 8, 16, 24 or 32. Packet sizes are 8000 bytes, 16000 bytes,
32000 bytes, and 64000 bytes.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module