Dell Force10 MXL Blade - Show Storm-Control Unknown-Unicast

Storm Control | 607
Example
Figure 32-2. show storm-control multicast Command Example
show storm-control unknown-unicast
Display the storm control unknown-unicast configuration
Syntax
show storm-control unknown-unicast [interface]
Parameters
Defaults
none
Command Modes
EXEC
EXEC Privilege
Command
History
Example
Figure 32-3. show storm-control unknown-unicast Command Example
storm-control broadcast (Configuration)
Configure the packets per second of broadcast traffic.
Syntax
storm-control broadcast [packets_per_second] in
To disable broadcast rate-limiting, use the no storm-control broadcast [packets_per_second] in
command.
FTOS#show storm-control multicast tengigabitethernet 1/0
Multicast storm control configuration
Interface Direction Packets/Second
-----------------------------------------------
TenGig 1/0 Ingress 5
FTOS#
interface
(OPTIONAL) Enter one of the following interfaces to display the interface specific storm
control configuration.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by
the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/
port information.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
FTOS#show storm-control unknown-unicast tengigabitethernet 3/0
Unknown-unicast storm control configuration
Interface Direction Packets/Second
-----------------------------------------------
TenGig 3/0 Ingress 1000
FTOS#