Dell Force10 MXL Blade - Page 606

606 | Storm Control
www.dell.com | support.dell.com
Parameters
Defaults
none
Command Modes
EXEC
EXEC Privilege
Command
History
Example
Figure 32-1. show storm-control broadcast Command Example
show storm-control multicast
Display the storm control multicast configuration.
Syntax
show storm-control multicast [interface]
Parameters
Defaults
none
Command Modes
EXEC
EXEC Privilege
Command
History
interface
(OPTIONAL) Enter one of the following interfaces to display the interface specific storm
control configuration.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed
by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/
port information.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
FTOS#show storm-control broadcast tengigabitethernet 3/24
Broadcast storm control configuration
Interface Direction Packets/Second
-----------------------------------------------
TenGig 3/24 Ingress 1000
FTOS#
interface
(OPTIONAL) Enter one of the following interfaces to display the interface specific storm
control configuration.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed
by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/
port information.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module