Dell Force10 MXL Blade - Snmp-Server Engineid

Simple Network Management Protocol (SNMP) and Syslog | 585
Parameters
Defaults
Not enabled.
Command Modes
CONFIGURATION
Command
History
Usage
Information
FTOS supports up to 16 SNMP trap receivers.
If you do not configure this command, no traps controlled by this command are sent. If you do not
specify a notification-type and notification-option, all traps are enabled.
Related
Commands
snmp-server engineID
Configure name for both the local and remote SNMP engines on the router.
Syntax
snmp-server engineID [local engineID] [remote ip-address udp-port port-number engineID]
To return to the default, use the no snmp-server engineID [local engineID] [remote ip-address
udp-port port-number engineID] command.
notification-type
Enter the type of notification from the list below:
•
ecfm — Notification of changes to ECFM
•
entity — Notification of changes to entity
•
envmon—Device notification when an environmental threshold is
exceeded
•
eoam — Notification of changes to the EOAM state
•
ets — Notification of changes to the ets traps
•
fips — Notification of changes to the FIP snooping state
•
lacp — Notification of changes to the LACP state
•
pfc — Notification of changes to pfc traps
•
snmp — Notification of RFC 1157 traps.
•
stp — Notification of state change in Spanning Tree protocol (RFC 1493)
•
vrrp—Notification of state change in a VRRP group
•
xstp—Notification of state change in MSTP (802.1s), RSTP (802.1w), and
PVST+
notification-option
For the envmon notification-type, enter one of the following optional
parameters:
• temperature
For the
snmp notification-type, enter one of the following optional parameters:
• authentication
• coldstart
• linkdown
• linkup
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
snmp-server community Enables SNMP and set the community string.