Dell Force10 MXL Blade - Clear Ip Dhcp; Debug Ip Dhcp Server

188 | Dynamic Host Configuration Protocol (DHCP)
www.dell.com | support.dell.com
clear ip dhcp
Reset DHCP counters.
Syntax
clear ip dhcp [binding {address} | conflict | server statistics]
Parameters
Command Mode
EXEC Privilege
Default
none
Command
History
Usage
Information
Entering <CR> after clear ip dhcp binding, clears all the IPs from the binding table.
debug ip dhcp server
Display FTOS debugging messages for DHCP.
Syntax
debug ip dhcp server [events | packets]
Parameters
Command Mode
EXEC Privilege
Default
none
Command
History
default-router
Assign a default gateway to clients based on address pool.
Syntax
default-router address [address2...address8]
Parameters
Command Mode
DHCP <POOL>
binding
Enter this keyword to delete all entries in the binding table.
address
Enter the IP address to clear the binding entry for a single IP address.
conflict
Enter this keyword to delete all of the log entries created for IP address
conflicts.
server statistics
Enter this keyword to clear all the server counter information.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
events
Enter this keyword to display DHCP state changes.
packet
Enter this keyword to display packet transmission/reception.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
address
Enter the a list of routers that may be the default gateway for clients on the subnet. You may
specify up to 8. List them in order of preference.