Dell Force10 MXL Blade - Terminal Length; Terminal Xml

76 | Control and Monitoring
www.dell.com | support.dell.com
Defaults
Not configured.
Command Modes
EXEC
EXEC Privilege
Command
History
Usage
Information
Telnet to link-local addresses is not supported.
terminal length
Configure the number of lines displayed on the terminal screen.
Syntax
terminal length screen-length
To return to the default values, use the terminal no length command.
Parameters
Defaults
24 lines
Command Modes
EXEC
EXEC Privilege
Command
History
terminal xml
Enable XML mode in Telnet and SSH client sessions.
Syntax
terminal xml
To exit the XML mode, use the terminal no xml command.
Defaults
Disabled
Command Modes
EXEC
EXEC Privilege
Command
History
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
screen-length
Enter a number of lines. Entering zero will cause the terminal to display without
pausing.
Range: 0 to 512.
Default: 24 lines.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module