Dell Force10 MXL Blade - Page 75

Control and Monitoring | 75
This display output is an accumulation of the same information that is displayed when you execute one
of the following show commands:
• show cam
• show clock
• show environment
• show file
• show interfaces
• show inventory
• show ip protocols
• show ip route summary
• show processes cpu
• show processes memory
• show redundancy
• show running-conf
• show version
Related
Commands
telnet
Connect through Telnet to a server. The Telnet client and server in FTOS supports IPv4 connections.
You can establish a Telnet session directly to the router, or a connection can be initiated from the
router.
Syntax
telnet {host | ip-address} [/source-interface]
Parameters
show version Displays the FTOS version.
show system Displays the current switch status.
show environment
Displays
system component status.
show processes memory Displays memory usage based on the running processes.
host
Enter the name of a server.
ip-address
Enter the IPv4 address in dotted decimal format of the server.
source-interface (OPTIONAL) Enter the keywords /source-interface followed by the interface
information to include the interface’s IP address.
Enter the following keywords and slot/port or number information:
• For a Loopback interface, enter the keyword loopback followed by a number
from zero (0) to 16383.
• For the Null interface, enter the keyword
null followed by 0.
• For a Port Channel interface, enter the keyword
port-channel followed by a
number:
Range: 1-128
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by
the slot/port information.
• For a VLAN interface, enter the keyword
vlan followed by a number from 1
to 4094.