Dell Force10 MXL Blade - Ip Igmp Version; Ip Igmp Snooping Enable

230 | Internet Group Management Protocol (IGMP)
www.dell.com | support.dell.com
Parameters
Defaults
10 seconds
Command Modes
INTERFACE
Command
History
ip igmp version
Manually set the version of the router to IGMPv2 or IGMPv3.
Syntax
ip igmp version {2 | 3}
Parameters
Defaults
2 (that is IGMPv2)
Command Modes
INTERFACE
Command
History
ip igmp snooping enable
Enable IGMP snooping on all or a single VLAN. This is the master on/off switch to enable IGMP
snooping.
Syntax
ip igmp snooping enable
To disable IGMP snooping, enter no ip igmp snooping enable command.
Defaults
Disabled
Command Modes
CONFIGURATION
INTERFACE VLAN
Command
History
Usage
Information
You must enter this command to enable IGMP snooping. When enabled from CONFIGURATION
mode, IGMP snooping is enabled on all VLAN interfaces (except default VLAN).
seconds
Enter the number of seconds for the maximum response time.
Default: 10 seconds
Range: 1 to 25
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
2 Enter the number 2 to set the IGMP version number to IGMPv2.
3 Enter the number 3 to set the IGMP version number to IGMPv3.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Note: You must execute the no shutdown command on the VLAN interface for IGMP
Snooping to function.