Dell Force10 MXL Blade - Ip Ftp Password; Ip Ftp Source-Interface

Control and Monitoring | 49
Usage
Information
The hostname is used in the prompt.
ip ftp password
Specify a password for outgoing FTP connections.
Syntax
ip ftp password [encryption-type] password
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
Usage
Information
The password is listed in the configuration file; you can view the password using the show
running-config ftp
command in EXEC mode.
Use the password configured by the ip ftp password command when you use the ftp: parameter in the
copy command.
Related
Commands
ip ftp source-interface
Specify an interface’s IP address as the source IP address for FTP connections.
Syntax
ip ftp source-interface interface
Parameters
Defaults
The IP address on the system that is closest to the Telnet address is used in the outgoing packets.
encryption-type
(OPTIONAL) Enter one of the following numbers:
• 0 (zero) for an unecrypted (clear text) password
• 7 (seven) for hidden text password
password
Enter a string up to 40 characters as the password.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
copy Copies the files.
ip ftp username Sets the user name for the FTP sessions.
interface
Enter the following keywords and slot/port or number information:
• For Loopback interfaces, enter the keyword
loopback followed by a number from
zero (0) to 16383.
• For a Port Channel interface, enter the keyword
port-channel followed by a number:
Range: 1-128
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the
slot/port information.
• For a VLAN interface, enter the keyword
vlan followed by a number from 1 to 4094.