Dell Force10 MXL Blade - Logging Trap

602 | Simple Network Management Protocol (SNMP) and Syslog
www.dell.com | support.dell.com
Defaults
Disabled. If enabled without level or number-of-buffers options specified, level = 2 and
number-of-buffers = 20 are the defaults.
Command Modes
LINE
Command
History
Usage
Information
When you enable logging synchronous , unsolicited messages appear between software prompts and
outputs. Only the messages with a severity at or below the set level are sent to the console.
If the message queue limit is reached on a terminal line and messages are discarded, a system message
appears on that terminal line. Messages may continue to appear on other terminal lines.
Related
Commands
logging trap
Specify which messages are logged to the Syslog server based the message severity.
Syntax
logging trap [level]
To return to the default values, use the default logging trap command. To disable logging, use the no
logging trap
command.
Parameters
Defaults
6 or informational.
Command Modes
CONFIGURATION
Command
History
Related
Commands
all Enter the keyword all to turn off all
limit number-of-buffers Enter the keyword limit followed by the number of buffers to be queued for
the terminal after which new messages are dropped
Range: 20 to 300
Default: 20
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
logging on Enables logging.
level
Indicate a value from 0 to 7 or enter one of the following parameters: emergencies, alerts,
critical, errors, warnings, notifications, informational, or debugging.
The default is 6.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
logging Enables the logging to another device.
logging on Enables logging.