Dell Force10 MXL Blade - Router Ospf

Open Shortest Path First (OSPFv2) | 407
Usage
Information
You can configure an arbitrary value in the IP address format for each router. However, each router ID
must be unique. If this command is used on an OSPF router process, which is already active (that is,
has neighbors), a prompt reminding you that changing router-id will bring down the existing OSPF
adjacency. The new router ID is effective at the next reload
router ospf
Enter the ROUTER OSPF mode to configure an OSPF instance.
Syntax
router ospf process-id
To clear an OSPF instance, use the no router ospf process-id command.
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
Example
Figure 21-3. router ospf Command Example
Usage
Information
You must have an IP address assigned to an interface to enter the ROUTER OSPF mode and configure
OSPF.
show config
Display the non-default values in the current OSPF configuration.
Syntax
show config
Command Modes
ROUTER OSPF
Command
History
Example
Figure 21-4. show config Command Example
process-id
Enter a number for the OSPF instance.
Range: 1 to 65535.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
FTOS(conf)#router ospf 2
FTOS(conf-router_ospf)#
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
FTOS(conf-router_ospf)#show config
!
router ospf 1
FTOS(conf-router_ospf-1)#