232 | Internet Group Management Protocol (IGMP)
www.dell.com | support.dell.com
ip igmp snooping last-member-query-interval
The last member query interval is the maximum response time inserted into Group-Specific queries
sent in response to Group-Leave messages. This interval is also the interval between successive
Group-Specific Query messages. Use this command to change the last member query interval.
Syntax
ip igmp snooping last-member-query-interval milliseconds
To return to the default value, enter no ip igmp snooping last-member-query-interval.
Parameters
Defaults
1000 milliseconds
Command Modes
INTERFACE VLAN
Command
History
ip igmp snooping mrouter
Statically configure a VLAN member port as a multicast router interface.
Syntax
ip igmp snooping mrouter interface interface
To delete a specific multicast router interface, use the no igmp snooping mrouter interface interface
command.
Parameters
Defaults
Not configured
Command Modes
INTERFACE VLAN — (conf-if-vl-n)
Command
History
Usage
Information
FTOS provides the capability of statically configuring interface to which a multicast router is attached.
To configure a static connection to the multicast router, enter the ip igmp snooping mrouter interface
command in the VLAN context. The interface to the router must be a part of the VLAN where you are
entering the command.
milliseconds
Enter the interval in milliseconds.
Default: 1000 milliseconds
Range: 100 to 65535
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
interface interface
Enter the following keywords and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by
the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel followed by a
number:
Range: 1 to 128
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
To Next Page
Loading...
