Dell Force10 MXL Blade - Show Qos Class-Map

480 | Quality of Service (QoS)
www.dell.com | support.dell.com
set
Mark outgoing traffic with a Differentiated Service Code Point (DSCP) or dot1p value.
Syntax
set {ip-dscp value | mac-dot1p value}
Parameters
Defaults
none
Command Modes
CONFIGURATION (conf-qos-policy-in)
Command
History
Usage
Information
After the IP DSCP bit is set, other QoS services can then operate on the bit settings.
show qos class-map
View the current class map information.
Syntax
show qos class-map [class-name]
Parameters
Defaults
none
Command Modes
EXEC
EXEC Privilege
Command
History
Example
Figure 25-1. show qos class-map Command Example
Related
Commands
ip-dscp value (OPTIONAL) Enter the keyword ip-dscp followed by the IP DSCP value.
Range: 0 to 63
mac-dot1p value
Enter the keyword mac-dot1p followed by the dot1p value.
Range: 0 to 7
On the MXL Switch, allowed values are:0,2,4,6
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
class-name
(OPTIONAL) Enter the name of a configured class map.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
FTOS#show qos class-map
Class-map match-any CM
Match ip access-group ACL
class-map Identifies the class map.