Dell Force10 MXL Blade - Page 479

Quality of Service (QoS) | 479
Usage
Information
A single policy-map can be attached to one or more interfaces to specify the service-policy for those
interfaces. A policy map attached to an interface can be modified.
Related
Commands
service-queue
Assign a class map and QoS policy to different queues.
Syntax
service-queue queue-id [class-map class-map-name] [qos-policy qos-policy-name]
To remove the queue assignment, use the no service-queue queue-id [class-map class-map-name]
[qos-policy qos-policy-name] command.
Parameters
Defaults
none
Command Modes
CONFIGURATION (conf-policy-map-in and conf-policy-map-out)
Command
History
Usage
Information
There are four (4) queues per interface on the MXL Switch. This command assigns a class map or QoS
policy to different queues.
Related
Commands
policy-map-output Creates an output policy map.
queue-id
Enter the value used to identify a queue.
Range:0-3 (four queues per interface; four queues are reserved for control
traffic.)
class-map
class-map-name
(OPTIONAL) Enter the keyword class-map followed by the class map
name assigned to the queue in character format (16 character maximum).
Note: This option is available under policy-map-input only.
qos-policy
qos-policy-name
(OPTIONAL) Enter the keyword qos-policy followed by the QoS policy
name assigned to the queue in text format (16 characters maximum). This
specifies the input QoS policy assigned to the queue under policy-map-input
and output QoS policy under policy-map-output context.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
class-map Identifies the class map.
service-policy input Applies an input policy map to the selected interface.
service-policy output Applies an output policy map to the selected interface.