Dell Force10 MXL Blade - Mac-Address-Table Station-Move Refresh-Arp; Mac Learning-Limit

Layer 2 | 339
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
Related
Commands
mac-address-table station-move refresh-arp
Ensure that ARP refreshes the egress interface when a station move occurs due to a topology change.
Syntax
[no] mac-address-table station-move refresh-arp
Defaults
none
Command Modes
CONFIGURATION
Command
History
Usage
Information
For details about using this command, refer to the “NIC Teaming” section of the Layer 2 chapter in the
FTOS Configuration Guide.
mac learning-limit
Limit the maximum number of MAC addresses (static + dynamic) learned on a selected interface.
Syntax
mac learning-limit address_limit [dynamic] [no-station-move | station-move] [sticky]
Parameters
mac-address
Enter the 48-bit hexidecimal address in nn:nn:nn:nn:nn:nn format.
output interface Enter the keyword output followed by one of the following interfaces:
• For a Port Channel interface, enter the keyword
port-channel followed
by a number:
Range: 1 to 128
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
followed by the slot/port information.
vlan vlan-id Enter the keyword vlan followed by a VLAN ID.
Range:1 to 4094.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
show mac-address-table Displays the MAC address table.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
address_limit
Enter the maximum number of MAC addresses that can be learned on the
interface.
Range: 1 to 1000000
dynamic (OPTIONAL) Enter the keyword dynamic to allow aging of MACs even
though a learning limit is configured.