Dell Force10 MXL Blade - Sflow Enable (Interface)

sFlow | 573
As part of the sFlow-MIB, if the simple network management protocol (SNMP) request originates
from a configured collector, FTOS returns the corresponding configured agent IP in management
information base (MIB) requests. FTOS checks to ensure that two entries are not configured for the
same collector IP with a different agent IP. Should that happen, FTOS generates the following error:
%Error: Different agent-addr attempted for an existing collector
sflow enable (Global)
Enable sFlow globally.
Syntax
sflow enable
To disable sFlow, use the no sflow enable command.
Defaults
sFlow is disabled by default
Command Modes
CONFIGURATION
Command
History
Usage
Information
In addition to this command, sFlow needs to be enabled on individual interfaces where you want sFlow
sampling.
Related
Commands
sflow enable (Interface)
Enable sFlow on Interfaces.
Syntax
sflow enable
To disable sFlow, use the no sflow enable command.
Defaults
sFlow is disabled by default on all interfaces
Command Modes
INTERFACE
Command
History
Usage
Information
When you enable sFlow on an interface, flow sampling is done on any traffic going out of the interface.
Related
Commands
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
sflow enable (Interface) Enables sFlow on interfaces.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Note: After a physical port is a member of a LAG, it inherits the sFlow configuration from
the LAG port.
sflow enable (Global) Turns sFlow on globally