Dell Force10 MXL Blade - Match Mac Dot1 P; Match Mac Vlan

Quality of Service (QoS) | 473
match mac dot1p
Configure a match criterion for a class map, based on a dot1p value.
Syntax
match mac dot1p {dot1p-list}
Parameters
Defaults
none
Command Modes
CLASS-MAP
Command
History
Usage
Information
You must enter the class-map command in order to access this command. After the class map is
identified, you can configure the match criteria.
Related
Commands
match mac vlan
Configure a match criterion for a class map based on VLAN ID.
Syntax
match mac vlan number
Parameters
Defaults
none
Command Modes
CLASS-MAP
Command
History
Usage
Information
You must first enter the class-map command in order to access this command. You can match against
only one VLAN ID.
Related
Commands
policy-aggregate
Allow an aggregate method of configuring per-port QoS via policy maps. An aggregate QoS policy is
part of the policy map (input/output) applied on an interface.
Syntax
policy-aggregate qos-policy-name
To remove a policy aggregate configuration, use the no policy-aggregate qos-policy-name command.
dot1p-list
Enter a dot1p value.
Range: 0 to 7
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
class-map Identifies the class map.
number
Enter the VLAN ID.
Range: 1 to 4094
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
class-map Creates/accesses a class map.