Dell Force10 MXL Blade - Debug Arp; Debug Ip Dhcp

294 | IPv4 Routing
www.dell.com | support.dell.com
Command Modes
EXEC Privilege
Command
History
debug arp
View information on ARP transactions.
Syntax
debug arp [interface] [count value]
To stop debugging ARP transactions, use the no debug arp command.
Parameters
Defaults
none
Command Modes
EXEC Privilege
Command
History
Usage
Information
Use the count option to stop packets from flooding the user terminal when debugging is turned on.
debug ip dhcp
Enable debug information for DHCP relay transactions and display the information on the console.
Syntax
debug ip dhcp
To disable debug, use the no debug ip dhcp command.
Defaults
Debug disabled
Command Modes
EXEC Privilege
Command
History
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
interface
(OPTIONAL) Enter the following keywords and slot/port or number information:
• For the Management interface, enter the keyword
managementethernet followed
by the slot/port information. The slot range is 0 and the port range is 0.
• For a Port Channel interface, enter the keyword
port-channel followed by a number:
Range: 1-128
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed
by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the
slot/port information.
• For a VLAN, enter the keyword
vlan followed by a number from 1 to 4094.
count value (OPTIONAL) Enter the keyword count followed by the count value.
Range: 1 to 65534
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module