Dell Force10 MXL Blade - Dei Enable; Dei Honor

656 | VLAN Stacking
www.dell.com | support.dell.com
• Dell Force10 recommends not using the same MAC address, on different customer VLANs, on the
same stackable VLAN.
• Interfaces configured using stackable VLAN access or stackable VLAN trunk commands do not
switch traffic for the default VLAN. These interfaces switch traffic only when they are added to a
non-default VLAN.
dei enable
Make packets eligible for dropping based on their drop eligible indicator (DEI) value.
Syntax
dei enable
Defaults
Packets are colored green; no packets are dropped.
Command Mode
CONFIGURATION
Command
History
dei honor
Honor the incoming DEI value by mapping it to an FTOS drop precedence. You can enter the
command once for 0 and once for 1.
Syntax
dei honor {0 | 1} {green | red | yellow}
Parameters
Defaults
Disabled; packets with an unmapped DEI value are colored green.
Command Mode
INTERFACE
Command
History
Usage
Information
You must first enable DEI for this configuration to take effect.
Related
Commands
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
0 | 1
Enter the bit value you want to map to a color.
green | red
| yellow
Choose a color:
• Green: High priority packets that are the least preferred to be dropped.
• Yellow: Lower priority packets that are treated as best-effort.
• Red: Lowest priority packets that are always dropped (regardless of congestion
status).
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
dei enable Enables DEI.