Dell Force10 MXL Blade - Track Ip

352 | Layer 2
www.dell.com | support.dell.com
Parameters
Defaults
All interfaces in Layer 2 mode are untagged.
Command Modes
INTERFACE VLAN
Command
History
Usage
Information
When you use the no tagged command, the interface is automatically placed in the default VLAN as
an untagged interface unless the interface is a member of another VLAN. If the interface belongs to
several VLANs, you must remove it from all VLANs to change it to an untagged interface.
Tagged interfaces can belong to multiple VLANs, while untagged interfaces can only belong to one
VLAN at a time.
Related
Commands
track ip
Track the Layer 3 operational state of a Layer 3 VLAN, using a subset of the VLAN member
interfaces.
Syntax
track ip interface
To remove the tracking feature from the VLAN, use the no track ip interface command.
Parameters
Defaults
Not configured
Command Modes
INTERFACE VLAN
Command
History
interface
Enter the following keywords and slot/port or number information:
• For a Port Channel interface, enter the keyword
port-channel followed by a number:
Range: 1-128
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the
slot/port information.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
interface vlan Configures a VLAN.
untagged Specifies which interfaces in a VLAN are untagged.
interface
Enter the following keywords and slot/port or number information:
• For a Port Channel interface, enter the keyword
port-channel followed by a
number:
Range: 1 to 128
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the
slot/port information.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module