Dell Force10 MXL Blade - Page 353

Layer 2 | 353
Usage
Information
When you configure this command, the VLAN is operationally UP if any of the interfaces specified in
the track ip command are operationally UP. The VLAN is operationally DOWN if none of the tracking
interfaces are operationally UP.
If you do not configure the track ip command, the VLAN's Layer 3 operational state depends on all the
members of the VLAN.
The Layer 2 state of the VLAN, and hence the Layer 2 traffic, is not affected by the track ip command
configuration.
Related
Commands
untagged
Add a Layer 2 interface to a VLAN as an untagged interface.
Syntax
untagged interface
To remove an untagged interface from a VLAN, use the no untagged interface command.
Parameters
Defaults
All interfaces in Layer 2 mode are untagged.
Command Modes
INTERFACE VLAN
Command
History
Usage
Information
Untagged interfaces can only belong to one VLAN.
In the default VLAN, you cannot use the no untagged interface command. To remove an untagged
interface from all VLANs, including the default VLAN, enter INTERFACE mode and use the no Port
Channel Commands command.
Related
Commands
interface vlan Configures a VLAN.
tagged Specifies which interfaces in a VLAN are tagged.
interface
Enter the following keywords and slot/port or number information:
• For a Port Channel interface, enter the keyword
port-channel followed by a number:
Range: 1-128
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the
slot/port information.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
interface vlan Configures a VLAN.
tagged Specifies which interfaces in a VLAN are tagged.