Dell Force10 MXL Blade - Vlan-Stack Access; Vlan-Stack Compatible

VLAN Stacking | 659
Related
Commands
vlan-stack access
Specify a Layer 2 port or port channel as an access port to the Stackable VLAN network.
Syntax
vlan-stack access
To remove access port designation, use the no vlan-stack access command.
Defaults
Not configured.
Command Modes
INTERFACE
Command
History
Usage
Information
Prior to enabling this command, to place the interface in Layer 2 mode, you must enter the switchport
command.
To remove the access port designation, the port must be removed (use the no member interface
command) from all stackable VLAN-enabled VLANs.
vlan-stack compatible
Enable the Stackable VLAN feature on a VLAN.
Syntax
vlan-stack compatible
To disable the stackable VLAN feature on a VLAN, use the no vlan-stack compatible command.
Defaults
Not configured.
Command Modes
CONF-IF-VLAN
Command
History
Usage
Information
You must remove the members prior to disabling the stackable VLAN feature.
To view the stackable VLANs, use the show vlan command in EXEC Privilege mode. Stackable
VLANs contain members, designated by the M in the Q column of the command output.
dei mark Sets the DEI value on egress.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module