Dell Force10 MXL Blade - Show Calendar; Ntp Update-Calendar

System Time and Date | 641
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
Usage
Information
The number parameter in the ntp trusted-key command must be the same number as the number
parameter in the ntp authentication-key command. If you change the ntp authentication-key command,
you must also change the ntp trusted-key command.
Related
Commands
ntp update-calendar
Configure the FTOS to update the calendar (the hardware clock) with the NTP-derived time.
Syntax
ntp update-calendar [minutes]
To return to default setting, use the no ntp update-calendar command.
Parameters
Defaults
Not enabled.
Command Modes
CONFIGURATION
Command
History
show calendar
Display the current date and time based on the switch hardware clock.
Syntax
show calendar
Command Modes
EXEC
EXEC Privilege
Command
History
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
ntp authentication-key Sets an authentication key for NTP.
ntp authenticate Enables the NTP authentication parameters you set.
minutes
(OPTIONAL) Enter the number of minutes between updates from NTP to the hardware
clock.
Range: 1 to 1440.
Default: 60 minutes.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module