Dell Force10 MXL Blade - Show Cam-Acl

Content Addressable Memory (CAM) | 149
cam-optimization
Optimize CAM utilization for QoS Entries by minimizing require policy-map CAM space.
Syntax
cam-optimization [qos]
Parameters
Command Modes
CONFIGURATION
Defaults
Disabled
Command
History
Usage
Information
When this command is enabled, if a Policy Map containing classification rules (ACL and/or dscp/
ip-precedence rules) is applied to more than one physical interface on the same port pipe, only a single
copy of the policy will be written (only one FP entry is used).
show cam-acl
Display the details of the CAM profiles on the chassis and all stack units.
Syntax
show cam-acl
Defaults
none
Command Modes
EXEC Privilege
Command
History
Usage
Information
The display reflects the settings implemented with the cam-acl command.
qos
Optimize CAM usage for Quality of Service (QoS)
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Note: An ACL may still require more that a single FP entry, regardless of the number of
interfaces. Refer to the IP Access Control Lists, Prefix Lists, and Route-map in the FTOS
Configuration Guide for complete description.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module