Dell Force10 MXL Blade - Show Range

274 | Interfaces
www.dell.com | support.dell.com
Related
Commands
show range
Display all interfaces configured using the interface range command.
Syntax
show range
Command Mode
INTERFACE RANGE (config-if-range)
Command
History
Example
Figure 14-38. show range Command Example
Related
Commands
Tx Power High Warning Flag This can be either true or false, depending on the Current Tx power value
displayed above.
Rx Power High Warning Flag This can be either true or false, depending on the Current Tx power value
displayed above.
Temperature Low Warning
Flag
This can be either true or false, depending on the Current Temperature value
displayed above.
Voltage Low Warning Flag This can be either true or false, depending on the Current voltage value
displayed above.
Tx Bias Low Warning Flag This can be either true or false, depending on the present Tx bias current value
displayed above.
Tx Power Low Warning Flag This can be either true or false, depending on the Current Tx power value
displayed above.
Rx Power Low Warning Flag This can be either true or false, depending on the Current Rx power value
displayed above.
Table 14-8. Diagnostic Data in show interfaces transceiver (continued)
Line Description
interface Configures a physical interface on the switch.
show ip interface Displays Layer 3 information about the interfaces.
show interfaces Displays information on a specific physical interface or virtual interface.
show inventory Displays the switch type, FTOS version including hardware identification
numbers and configured protocols.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
FTOS(conf-if-range-te-0/16)#show range
interface tengigabitethernet 0/16
FTOS(conf-if-range-te-0/16)#
interface Configures a physical interface on the switch.
show ip interface Displays Layer 3 information about the interfaces.
show interfaces Displays information on a specific physical interface or virtual interface.