Dell Force10 MXL Blade - Match Ip Next-Hop; Match Ip Route-Source

Access Control Lists (ACL) | 135
match ip next-hop
Configure a filter to match routes based on the next-hop IP addresses specified in an IP access list or IP
prefix list.
Syntax
match ip next-hop {access-list | prefix-list prefix-list-name}
Parameters
Defaults
Not configured.
Command Modes
ROUTE-MAP
Command
History
Related
Commands
match ip route-source
Configure a filter to match routes based on the routes advertised by routers specified in IP access lists
or IP prefix lists.
Syntax
match ip route-source {access-list | prefix-list prefix-list-name}
Parameters
Defaults
Not configured.
Command Modes
ROUTE-MAP
Command
History
match metric Redistributes routes that match a specific metric.
match route-type Redistributes routes that match a route type.
match tag Redistributes routes that match a specific tag.
access-list-name
Enter the name of a configured IP access list, up to 140 characters.
prefix-list prefix-list-name Enter the keywords prefix-list followed by the name of configured prefix
list.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
match interface Redistributes routes that match the next-hop interface.
match ip address Redistributes routes that match an IP address.
match ip route-source Redistributes routes that match routes advertised by other routers.
match metric Redistributes routes that match a specific metric.
match route-type Redistributes routes that match a route type.
match tag Redistributes routes that match a specific tag.
access-list-name
Enter the name of a configured IP access list, up to 140 characters.
prefix-list
prefix-list-name
Enter the keywords prefix-list followed by the name of configured prefix list,
up 10 140 characters.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module