358 | Link Layer Discovery Protocol (LLDP)
www.dell.com | support.dell.com
Parameters
Defaults
none
Command Modes
EXEC Privilege
Command
History
debug lldp interface
Enable LLDP debugging to display timer events, neighbor additions or deletions, and other
information about incoming and outgoing packets.
Syntax
debug lldp interface {interface | all}{events | packet {brief | detail} {tx | rx | both}}
To disable debugging, use the no debug lldp interface {interface | all}{events} {packet {brief |
detail} {tx | rx | both}} command.
Parameters
Defaults
none
Command Modes
EXEC Privilege
Command
History
interface
Enter the following keywords and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
tenGigabitEthernet
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the
slot/port information.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
interface
Enter the following keywords and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
tenGigabitEthernet
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by
the slot/port information.
all (OPTIONAL) Enter the keyword all to display information on all interfaces.
events (OPTIONAL) Enter the keyword events to display major events such as timer
events.
packet (OPTIONAL) Enter the keyword packet to display information regarding packets
coming in or going out.
brief (OPTIONAL) Enter the keyword brief to display brief packet information.
detail (OPTIONAL) Enter the keyword detail to display detailed packet information.
tx (OPTIONAL) Enter the keyword tx to display transmit only packet information.
rx (OPTIONAL) Enter the keyword rx to display receive only packet information
both (OPTIONAL) Enter the keyword both to display both receive and transmit packet
information.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
To Next Page
Loading...
