Dell Force10 MXL Blade - Page 359

Link Layer Discovery Protocol (LLDP) | 359
disable
Enable or disable LLDP.
Syntax
disable
To enable LLDP, use the no disable
Defaults
Enabled, that is no disable
Command Modes
CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Command
History
Related
Commands
hello
Configure the rate at which the LLDP control packets are sent to its peer.
Syntax
hello seconds
To revert to the default, use the no hello seconds command.
Parameters
Defaults
30 seconds
Command Modes
CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Command
History
mode
Set LLDP to receive or transmit.
Syntax
mode {tx | rx}
To return to the default, use the no mode {tx | rx} command.
Parameters
Defaults
Both transmit and receive
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
protocol lldp (Configuration) Enables LLDP globally.
debug lldp interface Debugs LLDP
show lldp neighbors Displays the LLDP neighbors
show running-config lldp Displays the LLDP running configuration
seconds
Enter the rate, in seconds, at which the control packets are sent to its peer.
Rate: 5 to 180 seconds
Default: 30 seconds
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
tx Enter the keyword tx to set the mode to transmit.
rx Enter the keyword rx to set the mode to receive.