Dell Force10 MXL Blade - Ip Rip Receive Version; Ip Rip Send Version

Routing Information Protocol (RIP) | 497
Related
Commands
ip rip receive version
Set the interface to receive specific versions of RIP. The RIP version you set on the interface overrides
the version command in ROUTER RIP mode.
Syntax
ip rip receive version [1] [2]
To return to the default, use the no ip rip receive version command.
Parameters
Defaults
RIPv1 and RIPv2
Command Modes
INTERFACE
Command History
Usage Information
If you want the interface to receive both versions of RIP, use ip rip receive version 1 2.
Related
Commands
ip rip send version
Set the interface to send a specific version of RIP. The version you set on the interface overrides the
version command in ROUTER RIP mode.
Syntax
ip rip send version [1] [2]
To return to the default value, use the no ip rip send version command.
Parameters
Defaults
RIPv1
Command Modes
INTERFACE
Command
History
Usage
Information
To enable the interface to send both version of RIP packets, use ip rip send version 1 2.
ip split-horizon Sets the RIP routing updates to exclude routing prefixes.
1 (OPTIONAL) Enter the number 1 for RIP version 1.
2 (OPTIONAL) Enter the number 2 for RIP version 2.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
ip rip send version Sets the RIP version to be used for sending RIP traffic on an interface.
version Sets the RIP version to be used for the switch software.
1 (OPTIONAL) Enter the number 1 for RIP version 1.
The default is RIPv1.
2 (OPTIONAL) Enter the number 2 for RIP version 2.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module