Dell Force10 MXL Blade - Show Running-Config

File Management | 31
show running-config
Display the current configuration and display changes from the default values.
Syntax
show running-config [entity] [configured] [status]
Parameters
entity
(OPTIONAL) Enter one of the keywords listed below to display that entity’s
current (non-default) configuration. Note that, if nothing is configured for
that entity, nothing is displayed and the prompt returns:
• aaa for the current AAA configuration
•
acl for the current ACL configuration
•
arp for the current static ARP configuration
•
boot for the current boot configuration
•
class-map for the current class-map configuration
•
fefd for the current FEFD configuration
•
ftp for the current FTP configuration
•
fvrp for the current FVRP configuration
•
host for the current host configuration
•
hardware-monitor for hardware-monitor action-on-error settings
•
igmp for the current IGMP configuration
•
interface for the current interface configuration
•
line for the current line configuration
•
load-balance for the current port-channel load-balance configuration
•
logging for the current logging configuration
•
mac for the current MAC ACL configuration
•
mac-address-table for the current MAC configuration
•
management-route for the current Management port forwarding
configuration
•
mroute for the current Mroutes configuration
•
ntp for the current NTP configuration
•
ospf for the current OSPF configuration
•
pim for the current PIM configuration
•
policy-map-input for the current input policy map configuration
•
policy-map-output for the current output policy map configuration
•
prefix-list for the current prefix-list configuration
•
privilege for the current privilege configuration
•
radius for the current RADIUS configuration
•
resolve for the current DNS configuration
•
rip for the current RIP configuration
•
route-map for the current route map configuration
•
snmp for the current SNMP configuration
•
spanning-tree for the current spanning tree configuration
•
static for the current static route configuration
•
tacacs+ for the current TACACS+ configuration
•
tftp for the current TFTP configuration
•
users for the current users configuration
•
wred-profile for the current wred-profile configuration