414 | Open Shortest Path First (OSPFv2)
www.dell.com | support.dell.com
Related
Commands
show ip ospf database network
Display the network (type 2) LSA information.
Syntax
show ip ospf process-id database network [link-state-id] [adv-router ip-address]
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Metrics Displays the LSA metric.
Forward Address Identifies the address of the forwarding router. Data traffic is forwarded to this
router. If the forwarding address is 0.0.0.0, data traffic is forwarded to the
originating router.
External Route Tag Displays the 32-bit field attached to each external route. This field is not used by
the OSPF protocol, but can be used for external route management.
Table 21-5. show ip ospf process-id database external Command Description
Item Description
show ip ospf database Displays OSPF database information.
process-id
Enter the OSPF Process ID to show a specific process.
If no Process ID is entered, command applies only to the first OSPF process.
link-state-id
(OPTIONAL) Specify LSA ID in dotted decimal format. The LSA ID value depends
on the LSA type, and it can be one of the following:
• the network’s IP address for Type 3 LSAs or Type 5 LSAs
• the router’s OSPF router ID for Type 1 LSAs or Type 4 LSAs
• the default destination (0.0.0.0) for Type 5 LSAs
adv-router
ip-address
(OPTIONAL) Enter the keywords
adv-router ip-address to display only the LSA
information about that router.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
To Next Page
Loading...
