Dell Force10 MXL Blade - Source (Port Monitoring)

Port Monitoring | 437
source (port monitoring)
Configure a port monitor source.
Syntax
source interface destination interface direction {rx | tx | both}
To disable a monitor source, use the no source interface destination interface direction {rx | tx | both}
command
.
Parameters
Defaults
none
Command Modes
MONITOR SESSION (conf-mon-sess-session-ID)
Command
History
Example
Figure 22-5. Configuring a Port Monitor Source Command Example
interface
Enter the one of the following keywords and slot/port information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
followed by the slot/port information.
destination Enter the keyword destination to indicate the interface destination.
direction {rx | tx | both} Enter the keyword direction followed by one of the packet directional
indicators.
rx: to monitor receiving packets only
tx: to monitor transmitting packets only
both: to monitor both transmitting and receiving packets
Version 8.3.16.1 Introduced on M I/O Aggregator
FTOS(conf-mon-sess-11)#source tengig 10/0 destination tengig 10/47 direction
rx
FTOS(conf-mon-sess-11)#