Dell Force10 MXL Blade - Show Ip Ospf

408 | Open Shortest Path First (OSPFv2)
www.dell.com | support.dell.com
show ip ospf
Display information on the OSPF process configured on the switch.
Syntax
show ip ospf process-id
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Usage
Information
If you delete all the network area commands for Area 0, the show ip ospf command output will not list
Area 0.
Example
Figure 21-5. show ip ospf process-id Command Example
Related
Commands
process-id
Enter the OSPF Process ID to show a specific process.
If no Process ID is entered, command applies only to the first OSPF process.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Table 21-2. show ip ospf process-id Command Descriptions:
Line Beginning with Description
“Routing Process...” Displays the OSPF process ID and the IP address associated with the
process ID.
“Supports only...” Displays the number of Type of Service (TOS) rouse supported.
“SPF schedule...” Displays the delay and hold time configured for this process ID.
“Convergence Level”
“Min LSA....” Displays the intervals set for LSA transmission and acceptance.
“Number of...” Displays the number and type of areas configured for this process ID.
FTOS#show ip ospf 10
Routing Process ospf 10 with ID 1.1.1.1 Virtual router default-vrf
Supports only single TOS (TOS0) routes
SPF schedule delay 5 secs, Hold time between two SPFs 10 secs
Convergence Level 0
Min LSA origination 0 msec, Min LSA arrival 1000 msec
Min LSA hold time 5000 msec, Max LSA wait time 5000 msec
Number of area in this router is 1, normal 1 stub 0 nssa 0
Area BACKBONE (0)
Number of interface in this area is 1
SPF algorithm executed 205 times
Area ranges are
FTOS#
show ip ospf database Displays information about the OSPF routes configured.
show ip ospf interface Displays the OSPF interfaces configured.
show ip ospf neighbor Displays the OSPF neighbors configured.