Dell Force10 MXL Blade - Show Interfaces Switchport

268 | Interfaces
www.dell.com | support.dell.com
show interfaces switchport
Display only virtual and physical interfaces in Layer 2 mode. This command displays the Layer 2
mode interfaces’ IEEE 802.1Q tag status and VLAN membership.
Syntax
show interfaces switchport [interface | stack-unit unit-id ]
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Example
Figure 14-36. show interfaces switchport Command Example
interface
Enter one of the following keywords and slot/port or number information:
• For a Port Channel interface, enter the keyword
port-channel followed by a
number:
Range: 1-128
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the
slot/port information.
• Enter the keyword
backup to view the backup interface for this interface.
stack-unit
unit-id
(OPTIONAL) Enter the keyword stack-unit followed by the stack member number.
Range: 0 to 5
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
FTOS#show interfaces switchport
Codes: U - Untagged, T - Tagged
x - Dot1x untagged, X - Dot1x tagged
G - GVRP tagged, M - Trunk, H - VSN tagged
i - Internal untagged, I - Internal tagged, v - VLT untagged, V - VLT
tagged
Name: TenGigabitEthernet 3/20
802.1QTagged: Hybrid
Vlan membership:
Q Vlans
U 20
T 10
Native VlanId: 20.
Name: TenGigabitEthernet 5/20
802.1QTagged: False
Vlan membership:
Q Vlans
U 1
Name: TenGigabitEthernet 5/21
802.1QTagged: False
Vlan membership:
Q Vlans
U 1
Name: TenGigabitEthernet 5/49 (Port-channel 128)
802.1QTagged: True
Vlan membership:
Q Vlans
G 10
Name: Port-channel 128
802.1QTagged: True
Vlan membership:
Q Vlans
FTOS#