Dell Force10 MXL Blade - Garp Timers

220 | GARP VLAN Registration (GVRP)
www.dell.com | support.dell.com
garp timers
Set the intervals (in milliseconds) for sending GARP messages.
Syntax
garp timers {join | leave | leave-all}
To return to the previous setting, use the
no garp timers {join | leave | leave-all} command.
Parameters
Defaults
Default as above
Command Modes
CONFIGURATION-GVRP
Command
History
Usage
Information
Join Timer—Join messages announce the willingness to register some attributes with other
participants. Each GARP application entity sends a Join message twice, for reliability, and uses a join
timer to set the sending interval.
Leave Timer—Leave announces the willingness to de-register with other participants. Together with
the Join, Leave messages help GARP participants complete attribute reregistration and de-registration.
Leave Timer starts upon receipt of a leave message sent for de-registering some attribute information.
If a join message is not received before the leave time expires, the GARP application entity removes
the attribute information as requested.
Leave All Timer—The Leave All Timer starts when a GARP application entity starts. When this timer
expires, the entity sends a leave-all message so that other entities can re-register their attribute
information. Then, the leave-all time begins again.
Related
Commands
join
Enter the keyword join followed by the number of milliseconds to configure the join
time.
Range: 100 to 147483647 milliseconds
Default: 200 milliseconds
Note: Designate the milliseconds in multiples of 100
leave Enter the keyword leave followed by the number of milliseconds to configure the leave
time.
Range: 100 to 2147483647 milliseconds
Default: 600 milliseconds
Note: Designate the milliseconds in multiples of 100
leave-all Enter the keyword leave-all followed by the number of milliseconds to configure the
leave-all time.
Range: 100 to 2147483647 milliseconds
Default: 1000 milliseconds
Note: Designate the milliseconds in multiples of 100
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
show garp timers Displays the current GARP times.