Dell Force10 MXL Blade - 26 Routing Information Protocol (RIP); Overview; Commands

Routing Information Protocol (RIP) | 491
26
Routing Information Protocol (RIP)
Overview
Routing information protocol (RIP) is a distance vector routing protocol. The Dell Force10 operating
software (FTOS) supports both RIP version 1 (RIPv1) and RIP version 2 (RIPv2).
The FTOS implementation of RIP is based on IETF RFCs 2453 and RFC 1058. For more information
about configuring RIP, refer to the FTOS Configuration Guide.
Commands
The following commands allow you to configure RIP:
• auto-summary
• clear ip rip
• debug ip rip
• default-information originate
• default-metric
• description
• distance
• distribute-list in
• distribute-list out
• ip poison-reverse
• ip rip receive version
• ip rip send version
• ip split-horizon
• maximum-paths
• neighbor
• network
• offset-list
• output-delay
• passive-interface
• redistribute
• redistribute ospf
• router rip
• show config
• show ip rip database