Dell Force10 MXL Blade - Ip Igmp Querier-Timeout; Ip Igmp Query-Interval

Internet Group Management Protocol (IGMP) | 229
Command
History
ip igmp querier-timeout
Change the interval that must pass before a multicast router decides that there is no longer another
multicast router that should be the querier.
Syntax
ip igmp querier-timeout seconds
To return to the default value, enter no ip igmp querier-timeout.
Parameters
Defaults
125 seconds
Command Modes
INTERFACE
Command
History
ip igmp query-interval
Change the transmission frequency of IGMP general queries sent by the Querier.
Syntax
ip igmp query-interval seconds
To return to the default values, enter no ip igmp query-interval.
Parameters
Defaults
60 seconds
Command Modes
INTERFACE
Command
History
ip igmp query-max-resp-time
Set the maximum query response time advertised in general queries.
Syntax
ip igmp query-max-resp-time seconds
To return to the default values, enter no ip igmp query-max-resp-time.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
seconds
Enter the number of seconds the router must wait to become the new querier.
Default: 125 seconds
Range: 60 to 300
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
seconds
Enter the number of seconds between queries sent out.
Default: 60 seconds
Range: 1 to 18000
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module