Dell Force10 MXL Blade - Show Lacp

Link Aggregation Control Protocol (LACP) | 335
Related
Commands
show lacp
Display the LACP matrix.
Syntax
show lacp port-channel-number [sys-id | counters]
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Example 1
Figure 17-2. show lacp port-channel-number Command Example
Example 2
Figure 17-3. show lacp sys-id Command Example
show lacp Displays the LACP information.
show interfaces port-channel Displays information on configured Port Channel groups.
port-channel-number
Enter a port-channel number:
Range: 1 to 128
sys-id (OPTIONAL) Enter the keyword sys-id and the value that identifies a
system.
counters (OPTIONAL) Enter the keyword counters to display the LACP counters.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
FTOS#show lacp 1
Port-channel 1 admin up, oper up, mode lacp
Actor System ID: Priority 32768, Address 0001.e800.a12b
Partner System ID: Priority 32768, Address 0001.e801.45a5
Actor Admin Key 1, Oper Key 1, Partner Oper Key 1
LACP LAG 1 is an aggregatable link
A - Active LACP, B - Passive LACP, C - Short Timeout, D - Long Timeout
E - Aggregatable Link, F - Individual Link, G - IN_SYNC, H - OUT_OF_SYNC
I - Collection enabled, J - Collection disabled, K - Distribution enabled L - Distribution disabled,
M - Partner Defaulted, N - Partner Non-defaulted, O - Receiver is in expired state,
P - Receiver is not in expired state
Port Te 10/6 is enabled, LACP is enabled and mode is lacp
Actor Admin: State ACEHJLMP Key 1 Priority 128
Oper: State ACEGIKNP Key 1 Priority 128
Partner Admin: State BDFHJLMP Key 0 Priority 0
Oper: State BCEGIKNP Key 1 Priority 128
FTOS#
FTOS#show lacp 1 sys-id
Actor System ID: Priority 32768, Address 0001.e800.a12b
Partner System ID: Priority 32768, Address 0001.e801.45a5
FTOS#