Dell Force10 MXL Blade - Common IP ACL Commands

94 | Access Control Lists (ACL)
www.dell.com | support.dell.com
Parameters
Defaults
none
Command Modes
EXEC
EXEC Privilege
Command
History
Usage
Information
When all sequence numbers have been exhausted, this feature permits re-assigning new sequence
numbers to entries of an existing prefix list.
Related
Commands
show config
Display the current ACL configuration.
Syntax
show config
Command Modes
CONFIGURATION-IP ACCESS-LIST-STANDARD
CONFIGURATION-IP ACCESS-LIST-EXTENDED
CONFIGURATION-MAC ACCESS LIST-STANDARD
CONFIGURATION-MAC ACCESS LIST-EXTENDED
Command
History
Example
Figure 6-2. show config Command Example
Common IP ACL Commands
The following commands are available within both IP ACL modes (Standard and Extended) and do not
have mode-specific options. When an access-list (ACL) is created without any rule and then applied to
an interface, ACL behavior reflects an implicit permit.
The MXL 10/40GbE Switch IO Module platform supports both ingress and egress IP ACLs.
prefix-list-name
Enter the name of configured prefix list, up to 140 characters long.
StartingSeqNum
Enter the starting sequence number to resequence.
Range: 0 to 65535
Step-to-Increment
Enter the step to increment the sequence number.
Range: 1 to 65535
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
seq Assign a sequence number to a deny or permit filter in an IP access list while
creating the filter.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
FTOS(conf-ext-nacl)#show conf
!
ip access-list extended patches
FTOS(conf-ext-nacl)#