Dell Force10 MXL Blade - Show Ip Dhcp Binding; Show Ip Dhcp Configuration

192 | Dynamic Host Configuration Protocol (DHCP)
www.dell.com | support.dell.com
Parameters
Command Mode
DHCP <POOL>
Default
Hybrid
Command
History
network
Specify the range of addresses in an address pool.
Syntax
network network /prefix-length
Parameters
Command Mode
DHCP <POOL>
Default
none
Command
History
show ip dhcp binding
Display the DHCP binding table.
Syntax
show ip dhcp binding
Command Mode
EXEC Privilege
Default
none
Command
History
show ip dhcp configuration
Display the DHCP configuration.
Syntax
show ip dhcp configuration [global | pool name]
type
Enter the NETBIOS node type.
Broadcast: Enter the keyword b-node.
Hybrid: Enter the keyword h-node.
Mixed: Enter the keyword m-node.
Peer-to-peer: Enter the keyword p-node.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
network/
prefix-length
Specify a range of addresses.
Prefix-length Range: 17-31
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module