Dell Force10 MXL Blade - Interface Range Macro Name; Interface Vlan

Interfaces | 249
interface range macro name
Run the interface-range macro to automatically configure the pre-defined range of interfaces.
Syntax
interface range macro name
Parameters
Defaults
none
Command Modes
CONFIGURATION
Command
History
Usage
Information
Figure 14-18 runs the macro named test that was defined earlier.
Example
Figure 14-18. interface-range macro Command Example
Related
Commands
interface vlan
Configure a VLAN. You can configure up to 4094 VLANs.
Syntax
interface vlan vlan-id
To delete a VLAN, use the no interface vlan vlan-id command.
Parameters
Defaults
Not configured, except for the Default VLAN, which is configured as VLAN 1.
Command Modes
CONFIGURATION
Command
History
Example
Figure 14-19. interface vlan Command Example
Usage
Information
For more information about VLANs and the commands to configure them, refer to Virtual LAN
(VLAN) Commands.
name
Enter the name of an existing macro.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
FTOS(conf)#interface range macro test
FTOS(conf-if-range-te-0/0-3,tengig-5/0-47,tengig-13/0-89)#
interface range Configures a range of command (bulk configuration)
interface range macro (define) Defines a macro for an interface range (bulk configuration)
vlan-id
Enter a number as the VLAN Identifier.
Range: 1 to 4094.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
FTOS(conf)#int vlan 3
FTOS(conf-if-vl-3)#