Dell Force10 MXL Blade - Show Ip Route

IPv4 Routing | 315
show ip route
View information, including how they were learned, about the IP routes on the switch.
Syntax
show ip route [hostname | ip-address [mask] [longer-prefixes] | list prefix-list [process-id] | all |
connected | static | summary]
Parameter
Command Modes
EXEC
EXEC Privilege
Command
History
Example
Figure 15-17. show ip route all Command Example
ip-address
(OPTIONAL) Specify a name of a device or the IP address of the device to view
more detailed information about the route.
mask
(OPTIONAL) Specify the network mask of the route. Use this parameter with
the IP address parameter.
longer-prefixes (OPTIONAL) Enter the keyword longer-prefixes to view all routes with a
common prefix.
list prefix-list (OPTIONAL) Enter the keyword list and the name of a configured prefix list.
See show ip route list.
process-id
(OPTIONAL) Specify that only OSPF routes with a certain process ID must be
displayed.
connected (OPTIONAL) Enter the keyword connected to view only the directly
connected routes.
all (OPTIONAL) Enter the keyword all to view both active and non-active routes.
static (OPTIONAL) Enter the keyword static to view only routes configured by the ip
route command.
summary (OPTIONAL) Enter the keyword summary. See show ip route summary.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
FTOS#show ip route all
Codes: C - connected, S - static, R - RIP,
B - BGP, IN - internal BGP, EX - external BGP,LO - Locally Originated,
O - OSPF, IA - OSPF inter area, N1 - OSPF NSSA external type 1,
N2 - OSPF NSSA external type 2, E1 - OSPF external type 1,
E2 - OSPF external type 2, i - IS-IS, L1 - IS-IS level-1,
L2 - IS-IS level-2, IA - IS-IS inter area, * - candidate default,
> - non-active route, + - summary route
Gateway of last resort is not set
Destination Gateway Dist/Metric Last Change
----------- ------- ----------- -----------
FTOS#