Dell Force10 MXL Blade - Match Interface; Match Ip Address

134 | Access Control Lists (ACL)
www.dell.com | support.dell.com
match interface
Configure a filter to match routes whose next hop is on the interface specified.
Syntax
match interface interface
To remove a match, use the no match interface interface command.
Parameters
Defaults
Not configured
Command Modes
ROUTE-MAP
Command
History
Related
Commands
match ip address
Configure a filter to match routes based on IP addresses specified in an access list.
Syntax
match ip address prefix-list-name
Parameters
Defaults
Not configured.
Command Modes
ROUTE-MAP
Command
History
Related
Commands
interface
Enter the following keywords and slot/port or number information:
• For the loopback interface, enter the keyword
loopback followed by a number from zero (0)
to 16383.
• For a Port Channel interface, enter the keyword
port-channel followed by a number:
Range: 1-128
• For a Ten Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by
the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port
information.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
match ip address Redistributes routes that match an IP address.
match ip next-hop Redistributes routes that match the next-hop IP address.
match ip route-source Redistributes routes that match routes advertised by other routers.
match metric Redistributes routes that match a specific metric.
match route-type Redistributes routes that match a route type.
match tag Redistributes routes that match a specific tag.
prefix-list-name
Enter the name of configured prefix list, up to 140 characters.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
match interface Redistributes routes that match the next-hop interface.
match ip next-hop Redistributes routes that match the next-hop IP address.
match ip route-source Redistributes routes that match routes advertised by other routers.