Dell Force10 MXL Blade - Default Vlan-ID

348 | Layer 2
www.dell.com | support.dell.com
default vlan-id
Specify a VLAN as the Default VLAN.
Syntax
default vlan-id vlan-id
To remove the default VLAN status from a VLAN and VLAN 1 does not exist, use the no default
vlan-id
vlan-id command.
Parameters
Defaults
The Default VLAN is VLAN 1.
Command Modes
CONFIGURATION
Command
History
Usage
Information
To return VLAN 1 as the Default VLAN, use this command syntax (default-vlan-id 1).
The default VLAN contains only untagged interfaces.
Related
Commands
default-vlan disable
Disable the default VLAN so that all switchports are placed in the Null VLAN until they are explicitly
configured as a member of another VLAN.
Defaults
The default VLAN is enabled.
Command Modes
CONFIGURATION
Command
History
Usage
Information
The no default vlan disable command is not listed in the running-configuration, but when you disable
the default VLAN, default-vlan disable is listed in the running-configuration.
name
Assign a name to the VLAN.
Syntax
name vlan-name
To remove the name from the VLAN, use the no name command.
Parameters
vlan-id
Enter the VLAN ID number of the VLAN to become the new Default VLAN.
Range: 1 to 4094.
Default: 1
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
interface vlan Configures a VLAN.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
vlan-name
Enter up to 32 characters as the name of the VLAN.